Skip to main content
Railway Maintenance

RXSOL 664 (Immersion Carbon and Paint Remover)

SKU: RXSOL-18-1811-025

RXSOL 664 is a diphase, liquid product based on volatile aliphatic solvent and also containing tar-acids, corrosion inhibitors and alkaline soaps. It is used for the removal of hard carbon and paint from engineering components and equipment. RXSOL  664 is a good general purpose, immersion paint remover and will usually remove the following types of organic finishes – cellulose paints, air drying alkyds and acrylics, one pack polyurethanes and some epoxies depending on type and nature of the substrate.

It should be noted that this information on paint types is given as a guide only: the removability of any particular paint in RXSOL 664 – or any other paint remover should always be assessed by practical trial before any production scale use.

Enquire Now

Application

Most of the applications of RXSOL  664 are in overhaul processes e.g. the reclaiming of paint rejects especially when these are made of sensitive alloys such as zinc, aluminium or magnesium and a cold, non-corrosive and economical paint remover is required.

RXSOL 664 is supplied and operated as a diphase system. The lower, solvent phase is the active one: the upper aqueous phase is a seal which reduces evaporation of solvents from the lower phase and serves as a reservoir of corrosion inhibitor salts.

Dosage

1. GENERAL :

RXSOL  664 is used as supplied at ambient temperatures. On no account must this product be heated as this will result in loss of the volatile solvent. Always use the complete contents of a container, in order to preserve the correct ratio of aqueous seal to active solvent layer. When first making up a bath of RXSOL 664 a note should be made of the depth of both the seal layer and the lower solvent layer. This makes subsequent control of the bath easier.

Components being processed in RXSOL 664 should be free of all oily and greasy contamination. Failure to ensure a grease and oil free condition of the work being processed will result in steadily increasing contamination of the bath and reduction in its life.

Oily and greasy components should be pretreated in a cold emulsifiable solvent cleaner, followed by a water rinse using an air/water gun and then immersion of the still wet components in RXSOL 664. Components must be completely immersed in the lower solvent layer with no intrusion into the upper seal layer. The seal has no paint or carbon removing ability.

2. RINSING

When treatment in RXSOL 664 is complete the work must be water rinsed. The rinsing equipment must produce sufficient pressure to remove detached paint and carbon from the surface along with residues of RXSOL 664.

NOTE The water rinse must be with cold water.

3. AFTER TREATMENT

After water rinsing, the work should be dried and suitably protected to prevent corrosion. A convenient means of drying that also provides some protection against corrosion is the use of a dewatering fluid .

Technical Specifications

Appearance: Two-phase liquid:

Lower layer: Dark brown.

Upper layer: Yellow.

Density: Lower layer: 1.170 to 1.180 g/ml at 20 C.

pH: Lower layer: 10.9 to 11.1

Flash Point: None.

These are typical values only and do not constitute a specification

About

RXSOL — Uganda Chemical is the East African supply arm of RX Marine International (RXSOL), supplying industrial chemicals and solvents since 1995. We deliver bulk solvents, degreasers, acids and alkalis, glycols, water-treatment chemicals, and laboratory reagents to customers across Uganda and the wider East African region.

Contact info

Industrial chemicals & solvents supplier since 1995.

ugandachemical.com @ gmail.com
+91 80699 76670

Featured Post