RXSOL
Metal Treatment
Pickling Dip Liquid
SKU: RXSOL-68-6805-005
RXSOL Pickling Liquid - Performs multiple cleaning action such as degreaser by removing oil effectively and also providing protective coating to keep rust free surface. Uses of Pickling liquid RXSOL helps to keep metal surface as priming after welding which can be used for Electrostatic Painting and powder coating. Also Uses of Pickling Liquid RXSOL helps to eliminate uses of all hazardous chemicals such as solvent, Acid, Phophate, Chromate etc. And its uses also helps to avoid sand scrubbing, blassting for metal surface preparation.
Application
The Pickling Dip Liquid fluid is recommended for immersion pickling of small objects and for pickling surfaces that are time-consuming to brush or spray pickle. It can also be used for circulation pickling of pipe systems. Pickling Liquid reduced the Re-work to Zero, saving a lot of labor, time & cost.
Dosage
Standard grades, such as 304 and 316: Mix 1 part Pickling Dip Liquid into 3 patrs of water. A further dilution can be done if longer pickling timesc an be accepted. High-alloyed grades, such as duplex grades (2205) and austenitic grades (904 L) for use in severe corrosive conditions: Mix 1 part of Pickling Dip Liquid in to 2 parts of water. Very high alloyed grades, such as super-austenitic (254 SMO) and super-duplex (2507) grades: Mix 1 part of Pickling Dip Liquid into 1 part of water.
1. Before first time use. Make the solution by adding the Pickling Dip Liquid to the water, not the other way round! The proportions depend on the steel to be pickled.
2. Pre-clean the objects to remove grease and oil before pickling by using RXSOL DEGREASER.
3. Place the product in the pickling bath.
4. Allow sufficient pickling time. Use 5 min to 4 hours depending on temperature, steel grade, condition of the Pickling Dip Liquid etc.
5. Rinse with high-pressure water jet after pickling.
6. Analyse the Pickling Dip Liquid content of acids and free metals regularly to maintain optimal Pickling Dip Liquid composition.
Technical Specifications
|
Physical state at 20oC |
: |
Colourless liquid |
|
Boiling point |
: |
80-100oC |
|
Flash point / Explosion properties |
: |
Not applicable |
|
Specific temperatures: |
: |
Solid-fluid 40oC, Fluid-gas 50-60oC (nitric fumes) |
|
Vapour pressure at 20oC |
: |
0.01 kPa |
|
pH |
: |
0 at 20oC |
|
Density |
: |
1.1-1.4 g/cm3 at 20oC |
|
Solubility in water at 20oC |
: |
100 weight % |
